How to Soft Reset Allview

A soft reset is a simple restart of your Allview device. It can be useful for resolving minor software glitches or issues without erasing any data.

Here’s how you can perform a soft reset on a Allview device.

1. Press and Hold the Power Button: Locate the power button on your Allview device. It’s usually located on the right or left side of the device.
2. Press and Hold: Press and hold the power button for about 10-15 seconds.
3. Release the Button: After holding the button for a few seconds, you’ll notice the device screen turning off.
4. Power On the Device: After the screen turns off, release the power button. Then, press and hold the power button again to turn on the device.

The device will boot up normally, and the soft reset should help clear any temporary issues that might have been affecting your device’s performance.

Please note that this process might slightly vary based on the specific model and software version of your Allview device. If you encounter any difficulties or differences in the process, you can refer to the official Allview website or user manual for the most accurate instructions.